The Shop > Tools

The Eddgwick arrived!

<< < (15/15)

mattinker:
AdeV,

I've searched the web for Thread dial information, and it turns out that Steve's "reconstitution" is spot on, nothing exotic or special about the Edgwick. Thanks again Steve!


--- Quote from: vtsteam on June 21, 2015, 05:25:01 PM ---Well we can intuit that it would probably say something like:

Take first cut when pointer is opposite proper mark. Repeat
for subsequent engagements.
For whole even number threads engage at any mark.
For whole odd number threads engage at any numbered mark.
For threads ending in 1/2 engage at the same mark.
For any odd Whitworth pitches and all metric threads keep guide.
screw nut engaged and return saddle by reversing feed clutch.

--- End quote ---

Regards, Matthew

vtsteam:
Glad to help if I can Matt -- I envy you your lathe, and very glad it ended up in good hands. :beer:

Navigation

[0] Message Index

[*] Previous page