The Craftmans Shop > New from Old
JCB 803 Saga
awemawson:
Now to start rebuilding it :bugeye:
The new kit seemed to be correct, and the 'hog rings' are actually identical to the ones I've used for fencing, so my Hog Ring Pliers actually fitted :thumbup:
I started with the squab - if I were doing it again I'd start with the back, as the squab foam make fitting those hog rings rather difficult.
awemawson:
Well it looks dramatically better than it did :clap:
That raising / tilting mechanism it too stiff to use but it matters not a lot
lordedmond:
So Andrew
Are you going to mill out a RR badge for it now sure looks comfy well done you are a inspiration to us all start a job and finish it
Stuart
DMIOM:
similar thoughts to Stuart - except my question was whether the next item would be a walnut veneer dash?
Dave
John Rudd:
It needs some bling :lol:
I feel a new thread coming on.......'Pimp my JCB 803'
Could be made into a tv series you know..... :coffee:
Nice jcb job on the seat Andrew..... :thumbup:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version