The Craftmans Shop > New from Old
JCB 803 Saga
awemawson:
--- Quote from: mattinker on July 13, 2015, 02:55:13 PM ---I'm glad you found the puncture, but I was a bit disappointed about the clay pigeon thrower!
Cheers, Matthew.
--- End quote ---
Update on that Matthew - we gave it much violence later on, knocking it very roughly back into shape. Then welded back the bits that broke off in the process. It has bars that channel the clays into the firing line and I don't know how critical their alignment is.
Whether it will actually work is debatable
mattinker:
So there is a glimmer of hope!
awemawson:
:doh: :doh:Yesterday was the day of the TWIT, with me in the starring role :doh: :doh:
All done and dusted, clean up, put the tools away, wipe down the controls with a clean rag, give the hydraulic tank a final top up (all rams need to be in the fully closed position for the level gauge to read correctly), then move the boom and dipper and bucket back to a more convenient position for parking up. Half way through I lost all controls, no movements at all. Hang on, what's that volcanic eruption just to the rear of my seat?
I'd forgotten to screw the hydraulic filler cap back on. This is actually the top of the filter unit and return oil enters just below the filler under slight pressure. I'd dumped about 35 litres of brand new hydraulic oil EVERYWHERE :bang:
35 litres of oil makes a BIG MESS :( Now fortunately the inner farm yard is deep road planings, which love a bit of oil to make them bind better together. Well they got a bit more than a bit !
I swept what I could off the concrete, and onto the planings, and the plan was that when I got back from the abattoir this morning, I'd dig out my steam cleaner, fire it up and steam clean the oil off the concrete. It's always been a bit temperamental firing up when it's been idle for a while, but try as I might I could NOT get the burner to fire. Ended up just pressure washing it off which worked remarkably well.
But I can see that I need to find a few days to 'breathe' on the pressure washer. It has a flame failure device that uses a CdS cell to look at the flame and decide whether to pump the oil or fire the ignition and I think I need to re-build it. I'd fit a commercial flame flailure unit from a domestic boiler, but this runs off 12V DC as the machine is completely self contained and doesn't use mains.
lordedmond:
Andrew
Are you sure you bought a JCB and not the Tory Canyon
If the size of the oil slick is a thing to go by
Good work on fixing it up but it seem that it has to have the lat word/spill
Stuart
Will_D:
Before doing anything radical to the FFD just check to see that the glass window/cell is clean as a build up of soot cuts down the light entering the photo cells!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version