| The Shop > Electronics & IC Programing |
| Programming Texas Instruments Microprocessors |
| << < (2/2) |
| John Rudd:
Not sure if this correct....but here goes anyway..... Setup a second pin as an output.....look at the code that has the timing loop, where it triggers the original output pin at 1 min intervals....mod the code so that it triggers the 2nd pin at the 1 second interval, but triggers the first after 60 secs..... Does this help you? |
| catceefer:
John, Thank you for the suggestion which chimes with what I was thinking and reassures me. The big problem that I have, or had (I think) was knowing how to configure the second pin. I could not work out the logic in naming pins and identifying them on the physical chip. However, the blog to which Abraham referred me has clarified this a lot. Regards, James. |
| Navigation |
| Message Index |
| Previous page |