Gallery, Projects and General > Project Logs
Quick Change Tool Post for Raglan 5inch Lathe
<< < (3/5) > >>
Meldonmech:

 The remaining parts were straight forward machining ball handles etc. the tool holders were assembled, and tool post set up. A trial was completed, and I was pleased with the results.

                                                              Cheers David
vtsteam:
Hey I like your mill table clamping blocks!!! :thumbup:

And David, really satisfying to see all those toolholders and the finished post! Great job! :bow: :bow:  :clap: :clap: :beer:

NormanV:
I have a Dickson QCTP, the tool holders are silly prices. It had never occurred to me that cast aluminium would be ok for tool holders. I will be looking at it more carefully now. I could cast long sticks to make the machining quicker and then cut them off to size.
awemawson:
Saturate your molten aluminium with copper Norman to make it significantly harder.
Meldonmech:
 
 Norman, you are quite right, on my last batch I made a new pattern and cast a block of six. After machining the block to size, dovetailed the block then sawed the tool holders into six.
                           
          This is definitely the way to go.
                                                                         Cheers David


                                                             
Navigation
Message Index
Next page
Previous page

Go to full version