| Gallery, Projects and General > How do I?? |
| threading |
| (1/5) > >> |
| polecat:
morning all i have a pcp air reciever i need to make a plug to seal the ends the id is 20.5mm it has a 1.25mm thread inside the tube what size do i turn the plug before threading i dont know new to this thanks polecat |
| polecat:
am i right in thinking the thread stub should be 21.75mm dia so if i cut a 1.25pitch thread it should fit the id of 20.50 of the tube which is already threaded thanks polecat |
| polecat:
anybody if you know tell me please am i right polecat |
| RobWilson:
Hi Polecat What pressure will this be operating @ ? where was it manufactured ? If it was 22mm x 1.25 , I would expect the bore to be 20.75,,,,,,,,,,,,,,,, 1.25 mm pitch is VERY close to 20TPI and 22mm is very close to 7/8 ,,,,,,,,, and 7/8 20 is used in high pressure fittings . Rob |
| polecat:
rob it is a 19" falcon air rifle tube all pressure tested so no worries will check your suggestions thanks polecat |
| Navigation |
| Message Index |
| Next page |