Gallery, Projects and General > Project Logs
Building a New Lathe
vtsteam:
While not completely finished (it needs cheeks and a set screw) I slipped it on the motor shaft and got a measurement for the belt - 28.4". The closest available matches were 280XL063 and 290XL063 so I ordered both. Delivery by July 2. Won't be turning anything before then, for sure.
No longer a lowly sprue.
Homebrewer:
Looking pretty fantastic so far!
Are you still planning to drive the leadscrew electronically or with a series of belts as well?
Sent from my SM-G950U using Tapatalk
vtsteam:
Thanks Homebrewer. :beer: Not sure about the electronic leadscrew, yet.
The driver pulley and some 5/8" washers:
vtsteam:
Opening washers for drive fit.
vtsteam:
Finished pulley:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version