Gallery, Projects and General > Neat Stuff

I had a length of 1in brass bar, square section

<< < (2/2)

AlanT:
The hinges are a good bit harder than the wiper-jets because the axle does not run parallel to the base.
Also the two axles need to line up when the hinges are in place or the boot lid would need to flex as you raised it.

There is only about 2mm wall thickness left, on the tail-end, above the stud which hold them on.

There was still some bar left, but the next job will get its own topic, because I have more photos.

hermetic:
MG Midget? Sprite? don't keep us in suspense!
Phil

AlanT:
TR4A

Navigation

[0] Message Index

[*] Previous page