The Shop > Tools
SIEG X2 and X3 size questions
ja2on:
Hi guys just a quick question/request to X2 mini mill and X3 small mill owners. :wave:
I have 54.5" of bench width left will I be able to fit and use a X2 or X3 ?
I have the measurements from sieg's web site but cannot figure out how far the table will move :doh:
Brass_Machine:
I will check my bench space later for the X2 for you.
Eric
ja2on:
Thanks :thumbup:
Brass_Machine:
With that amount of space... you could most definitely fit a X2 there. The bench mine is on is 48" and I am not using all of it... maybe 1/2 to 2/3. Don't know about a X3. I plan to put a X3 in the spot my X2 is... so if it would work for me, should work for you.
Eric
ja2on:
Thanks again Eric :thumbup:
what has me confused is the longitudinal travel
For example the X2 is listed as
length 520mm
width 500mm
hight 760mm
longitudinal travel 220mm
and the X3 as
length 760mm
width 720mm
hight 930mm
longitudinal travel 400mm
Does this mean I have to add the longitudinal travel measurement to both sides of the machines width :scratch:
or half each side ?
or is it not that simple
Navigation
[0] Message Index
[#] Next page
Go to full version