| The Shop > Tools |
| SIEG X2 and X3 size questions |
| (1/2) > >> |
| ja2on:
Hi guys just a quick question/request to X2 mini mill and X3 small mill owners. :wave: I have 54.5" of bench width left will I be able to fit and use a X2 or X3 ? I have the measurements from sieg's web site but cannot figure out how far the table will move :doh: |
| Brass_Machine:
I will check my bench space later for the X2 for you. Eric |
| ja2on:
Thanks :thumbup: |
| Brass_Machine:
With that amount of space... you could most definitely fit a X2 there. The bench mine is on is 48" and I am not using all of it... maybe 1/2 to 2/3. Don't know about a X3. I plan to put a X3 in the spot my X2 is... so if it would work for me, should work for you. Eric |
| ja2on:
Thanks again Eric :thumbup: what has me confused is the longitudinal travel For example the X2 is listed as length 520mm width 500mm hight 760mm longitudinal travel 220mm and the X3 as length 760mm width 720mm hight 930mm longitudinal travel 400mm Does this mean I have to add the longitudinal travel measurement to both sides of the machines width :scratch: or half each side ? or is it not that simple |
| Navigation |
| Message Index |
| Next page |