| Gallery, Projects and General > The Design Shop |
| Gas jet resizing |
| (1/1) |
| Bangkok Mick:
Hi all, I am looking to get some more heat from my gas burner for steam engine boiler to increase the head of steam. The original fitting and jet was from Macsteam with a jet with a number 5 printed on the side. I plan to change this with a jet I have salvaged from an old soldering gas torch. Has anyone any advice on the maximum size jet that is safe to use? The new jet is a pin hole in a thin foil as in the picture, is safe to increase this size with a pin to open up the gas flow or am I risking a blow back or some other failure that could make the system unsafe. Cheers Mick |
| R.G.Y.:
Just get a number 8 jet cheep enough. |
| Navigation |
| Message Index |