Gallery, Projects and General > Project Logs

Mill Power feed

<< < (19/26) > >>

sbwhart:
Nice job Darren

 :thumbup: :thumbup:

I can see what you were explaining about the handle on your mill making things awkward.

On the face of it it will be easyer on my mill.

Stew

sbwhart:
Her's a question

 :scratch:

As my machine has an handle at one end and the facilties for a drive at the other would it harm if I had the motor permeantly engauged ?.

Stew

Divided he ad:

--- Quote ---Her's a question

  :scratch:

As my machine has an handle at one end and the facilties for a drive at the other would it harm if I had the motor permeantly engauged ?.

Stew
--- End quote ---

Heavily geared motors Stew.... Most unlikely to work!  try turning it with a nut on the end of the shaft.... Should make it really clear!!  :thumbup:



Darren,

Much easier on your mill!

I'll get it done, even if I have to re-design the drive!!  :thumbup:



Ralph.

Darren:
Stew, don't try to turn the shaft by hand, you might strip the teeth off the big gear.
Unlikely by hand, but you could probably do it with a hand wheel attached, like on the mill.  :thumbup:

Hence the disconnectin thingi bob wotsit

One gear is a worm wheel

sbwhart:
OK Thanks for putting me straight Chaps

I'm not planning on doing anything just yet, Johns got some toothed belt drives for me to look at that may do the job.

Stew

Navigation

[0] Message Index

[#] Next page

[*] Previous page