The Shop > Tools

DTI holder for lathe toolpost

<< < (2/3) > >>

krv3000:
brill job i bit off topic got you sum 20mm thick by 180mm by 130mm plate for your vice

micktoon:
 Hi Lads, thanks for the comments , its so easy to make its got to be done eh !
  Steamer , good idea to have a finger attachment on the end for inside a bore....thats the beauty of forums half an idea starts off and its a proper job by the time a few others add to it, I don't have a decent finger dial but once I get one I will be adding that too cheers  :thumbup:

  Aye John , its sure a nice sight that 3 jaw on the lathe lol, thanks again for assistance mate  :clap:

  Well done Bob, thanks ,  that sounds like it will do the job lovely  :dremel: :thumbup: :bow:

 Cheers Mick

dawesy:
On my list when I get a QCTP. Excellent idea and nicely made too

Meldonmech:
 
   Hi Mick, neat little Job.  I have all the necessary construction parts, in my come in handy box. Should make a nice casual weekend in the workshop for a change, may even only take a relaxing Sunday morning.

                                                                       Cheers David

chipenter:
I made some holders and a smaller one for the dial guage , slacked the screw and it flips 90 degrees .

Navigation

[0] Message Index

[#] Next page

[*] Previous page