Gallery, Projects and General > Neat Stuff

Neat router jig

(1/2) > >>

shipto:
This showed up on my farcebook page thought it was a good idea never seen this before.
Wasnt sure if I should put it in wood n stuff though.

steampunkpete:
Nice idea. I might try that when I make the doors for the new benches in my garage / workshop.

chipenter:
That arrow looks the wrong way round to me , you would realy have to hang on to the router to stop it running away .

mechman48:
I can see where the arrow direction is coming from ( pun intended  :D ) as it's going from conventional milling to climb milling for ea. 120* rotation so chip is correct in that the router is liable to try & run away from direction of cut, I'm not a carpenter just my tu'pennorth.. :scratch:

Geroge

vtsteam:
Anyway, cool idea with the proper direction!  :beer:

Navigation

[0] Message Index

[#] Next page