« previous next »
Pages: [1]   Go Down

Author Topic: CNC Wire Bending  (Read 4482 times)

Offline Joules

  • Hero Member
  • *****
  • Posts: 1278
  • Country: gb
CNC Wire Bending
« on: February 19, 2015, 09:47:27 AM »
Apologise if this has been posted before but I couldn't find it.  I was really impressed by the use of the CNC mill in this application.  I may even be tempted to just motorise the X,Y axis on my small mill to do this.

     


Hope its of interest.
« Last Edit: February 19, 2015, 10:47:16 AM by dsquire »
Logged
Honour your mentors, and pay it forward.

Offline awemawson

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 9015
  • Country: gb
  • East Sussex, UK
Re: CNC Wire Bending
« Reply #1 on: February 19, 2015, 11:34:18 AM »
A neat idea that. I don't suppose you could work on very heavy gauge rod before the radial spindle load is too much for the bearings.

Certainly a method to tuck away for the future  :thumbup:
Logged
Andrew Mawson
East Sussex

Offline Joules

  • Hero Member
  • *****
  • Posts: 1278
  • Country: gb
Re: CNC Wire Bending
« Reply #2 on: February 19, 2015, 11:43:27 AM »
Thats a fair point Andrew.  Perhaps have a jig attached to the mill head than risk the spindle bearings, and make sure the bending roll is the weak link...
Logged
Honour your mentors, and pay it forward.
Pages: [1]   Go Up
« previous next »