Gallery, Projects and General > Project Logs
Coke Forge Build
Pete W.:
Rob's work is so amazing :bugeye: :bugeye: :bugeye: that I have to take a courage pill before I dare post my simple stuff! :doh: :doh: :doh:
vtsteam:
I second that, Pete.... :bow: :bow: :bow: :bow:
RobWilson:
Thanks Joe , Pete and Steve :beer: :wave:
I need a valve to control the air flow , so I decided to make a butterfly valve :dremel:
The valve body so far. Machined from a bit mystery steel .
Setting the flat in the correct orientation with the PCD of the slots .
Body done :dremel:
And a couple of BRASS bushes (not to be confused with Bronzes as that's quite different :palm: ) for the spindle were machined up and pressed into the body .
I Nickel plated the valve body to give it some corrosion resistances :zap:
Rob
NeoTech:
Hmpf, i have Aciera as well.. why doesnt my bits look like that. ;D
RobWilson:
--- Quote from: NeoTech on February 21, 2015, 02:09:28 PM ---Hmpf, i have Aciera as well.. why doesnt my bits look like that. ;D
--- End quote ---
:) I am sure it works the same Neo :poke: :lol:
Decided to do something different today , so I etched up some name plates to go on the forge and blower , smaller two are to go on some tooling I have made .
Undecided on weather or not to add a colour infill :scratch:
Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version