Gallery, Projects and General > Project Logs

Coke Forge Build

<< < (37/53) > >>

doubleboost:
Very nice Rob    :drool: :drool: :drool:
The plasma saves loads of time (and cutting discs) :doh: :doh: :doh: :doh:
John

RobWilson:
Hi Chaps   :wave:


Decided to do a bit work on the forge today , welded some very old and rusty steel onto the stand for feet .






and decided to cut a section of the hearth away  .

before .


 


after 




First time I have used the yard vice ,







 much better grinding out side , needs two mods , it's about 2" to high and it needs somewhere to hand a grinder   :scratch:


Rob

vtsteam:
Hey Rob! :wave:

I need one of them outdoor vices! :thumbup:

Pete49:
+1 for the yard vice. Looks like another project added to the list, though it might make the top of it.
Pete

RobWilson:
Cheers Steve and Pete  :beer:

A yard vice is a must  :dremel:

Got a tad more done today ,was going great guns up until I pulled a muscle in my back  :( , so I will post this for now   , first job this morning was to cut down the yard vice stand

by 2" and add two bits of flat bar so that I can hang gear from them .

 
 


Then another job I have been meaning to do is add a hook to the 8" grinder , this was made from a bolt .

 





That done I could get back on with the forge , I am using up my old rusty stock on this project , this was cleaned up with the above grinder .




and cut and welded into this .




this being to support the hood and back panel .




deciding whether to bolt or weld it to the hearth .


cheers Rob

Navigation

[0] Message Index

[#] Next page

[*] Previous page