Gallery, Projects and General > Gallery

ed lights for mill,,

<< < (5/8) > >>

Will_D:

--- Quote from: Colh on February 19, 2015, 07:08:09 PM ---When I dismantled my mill to fit the DRO scales I had the foresight to weigh the head - 27kgs.  I will look for a strut with a power around 27 Newtons. 

--- End quote ---
"So 1kg mass x 9,81 m/s^2 = 9,81N ~ approximately 10N."

So you need 270 Newtons :doh:

steampunkpete:

--- Quote ---So you need 270 Newtons
--- End quote ---

In the words of a well known Time Lord "Correctamundo". (Yes)  :)

mechman48:
I wonder what Isaac would make of all this jocularity.... & leaps in science... probably ROTFLHAO..  :scratch:
George

stirling lad:


    ..So my mills head weighs around half an imperial slug......I see what you mean,,,..... where's the aspirin?? :palm:


  ...m..

rleete:
I used a round "angel eye" ring.  Sold for customizing car headlights.  Bought 2 for a couple bucks, shipped.  They are 12 volt, so require a separate power supply.  for that I bought a wall wart adapter; one that's 110v in, 12v out.  That was also a couple of bucks shipped.  Both items were purchased on ebay.

The ring is the perfect size to fit around the spindle of the mill.

Navigation

[0] Message Index

[#] Next page

[*] Previous page