Gallery, Projects and General > Gallery

First bit of proper turning and threading.

<< < (3/4) > >>

dawesy:
Thanks guys :)
Yep all done on the old Churchill ;)
Cap all done now bar knurling


Seals going in the cap Russell
You can just about see the undercut in this pic



Going to practice knurling first before I do the cap :/
Also going to trim down the threads on the neck as I think I must have knocked the verniers when I measured it to get the depth for the cap :(

BillTodd:
Caution:  If that is stainless steel - grease the threads with copper slip (anti-seize)  or you may not get it apart again ! :thumbup:

dawesy:
Thanks for the heads up bill but its aluminium ;)

PJW:
A nice bit of turning, a job to be proud of :clap:

Peter

dawesy:
Thank you Peter. The tank is almost finished

Navigation

[0] Message Index

[#] Next page

[*] Previous page