Gallery, Projects and General > Project Logs
Rebuiding a RC HiLux 4x4
<< < (2/2)
modeldozer:
Hi all.

One of the shafts in the gearbox had to be pressed apart.  After fitting the bearings the pinion was cross drilled and pined to the shaft.



All ready for assembly.



And assembled.



The shock absorbers were also rebuilt with new seals and oil.





All mounted back on the chassis.







Till later.
Abraham

modeldozer:
Managed to get a bit more done.
Some of the servo mounts were broken so new ones were made from square MS bar.





The original speed controller was giving problems and was replaced with a modern electronic one.



Made some caps to blank off the unused servo pivot hole.





Also made a support for the new switch, which is quite a bit smaller than the original.



Servos, ESC and receiver fitted.



Cheers
Abraham
Phill05:
Looking good
vtsteam:
 :coffee: :coffee:
Navigation
Message Index
Previous page

Go to full version