| The Craftmans Shop > New from Old |
| Anyone fancy a REAL challenge |
| << < (8/9) > >> |
| RotarySMP:
Would be wonderful lathe again if repaired and restored. |
| Manxmodder:
And that one is still a very reasonable price even with the damaged parts on it. There are no far Eastern products that could come close to the quality of a machine like a DS&G,yet people willingly pay over £2 grand for a new machine that will then need a load of modifying to make it satisfactory. I shake my head :palm: |
| Pete.:
Bit less of a challenge this one just needs a good clean-up and go-over. even if it's a bit worn it's still a stonking good lathe: http://r.ebay.com/tQbbHw |
| Manxmodder:
Pete, those CVA's are also a good sturdy machine. I've spent many hours turning on one very similar to this,and one of the features I always liked was the cross slide micrometer dial reads diametrically,so if you dial in 5 thou on the wheel then that is the amount the component dia is reduced by......OZ. |
| vintageandclassicrepairs:
Hi All, Another fine lathe sadly neglected :( There seems to be quite a few on ebay at the moment http://www.ebay.co.uk/itm/harrison-lathe/111580439696?_trksid=p2047675.c100009.m1982&_trkparms=aid%3D222007%26algo%3DSIC.MBE%26ao%3D1%26asc%3D20140328180637%26meid%3D481724419d89401b96cd9fbfb1791f2e%26pid%3D100009%26rk%3D3%26rkt%3D10%26sd%3D321648574283 John |
| Navigation |
| Message Index |
| Next page |
| Previous page |