Toolpost holder holder

Gallery, Projects and General > Project Logs

<< < (3/8) > >>

Bernd:
Bogs,

You've come up with another novel idea. I've seen all sorts of fancy holders for hanging those types of tool holders on, but a piece of wood and some round stock takes the cake.

Great idea. I love it. :thumbup:

Can't wait to see the finished project. :clap:

Bernd

HS93:
Didnt they write a song for you John

"Bogs the builder can he do it.... YES HE CAN "

Peter

Sorry John I was bord

:ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb: :ddb:

bogstandard:
On my foraging trip this morning, turned the corner and found a load of pre cut trees cowering in one of my storage areas, so I gave the biggest one a wack with an hammer, and dragged it back to the shop.

Once inside, it was dispatched humanely and was butchered to get the three limbs I required.
They were held together with a couple of coachbolts while I drilled holes all over the place.
Twenty in the top one, but I actually ended up with sixty very accurately drilled holes.

Just to make sure they were dead, I wacked in 60 metal pins to the correct depth.
A couple of holes in each one will allow my trophies to hang on the wall.

Up on the wall, and I found they were a perfect place to hang my toolholders on. All sorted into type and how often they are used.
So a little plastic rack underneath finished the job off, I can put all my tips and ground up tooling in that.

I now do have to get on with a commission job, so that will be about a week before I can go searching for any more little jobs to do.

Bogs

John Hill:
Nice work Bogster, do you have any plans for lower levels in that corner of the 'shop?

I always seem to end up putting stuff in a corner which is never used the end result being wasted space. :scratch:

sbwhart:
Nice neat job John that will make your time more productive

:whip:

Stew

Navigation

 Message Index

Go to full version