The Shop > Our Shop
Rev counter for miller
PJW:
I have just fitted this rev counter on my miller, the on /off switch & speed control are all in one, not ideal. this unit was pointed out to me by Sterlinglad, Thanks! it was purchased on a well known auction site listed as 4 Digital Tachometer RPM Speed Meter Red LED + Proximity Switch Sensor, it only cost £6.99 and was fitted an an hour, it works a treat!!!
drmico60:
Hi PJW,
I have just bought a similar tacho. There is no wiring instructions in English just some Chinese characters on the 5 pin lug on the display. Have you any info on what connects to what?
Mike
Will_D:
On the strength of this vaguely interesting thread I have just lashed out 7 quid for a blue one.
Do they supply a bit of magnet?
The sensor is a Hall effect (ie magnetic) so you just mount a small bit of magnet on the rotaing bit and position the sensor between 1 and 10 mm from it and Bob should be your Da's Bro
However when it arrives it may be a case of "Fanny is not my Aunty"
chipenter:
I have two of thees and the wiring instructions were on the ebay post , nothing came with them one came with a magnet and one without .
mfletch:
be warned the magnet only works one way
Navigation
[0] Message Index
[#] Next page
Go to full version