Gallery, Projects and General > Mod-Ups!

Pipe and Bolt Engine Mod-Up

<< < (20/50) > >>

vtsteam:
Ain't it a hoot, OZ?  :lol:

Manxmodder:
That's looking really good Steve,I'd think  your design is probably going to be replicated a good number of times in the future for a novelty engine project  :thumbup:

I found something else in the scrap pile that also had 'novel engine' written all over it. A hydraulic brake wheel cylinder with a bore of 1.125".

Worth consideration for a future 'bonkers as a box of frogs' engine.......OZ.

vtsteam:
Oz I've always wanted to try one of those as a power cylinder for a hot air engine! Future mod-up?  :drool:

vtsteam:
Conrod shortened and brazed  to the leftover piece of cast iron to make small end:

vtsteam:
And some sawing, filing and drilling later, I have the rod done. I hope it's the right length! As you can tell, no milling cutter was harmed in the construction of this engine..... :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page