Gallery, Projects and General > Mod-Ups!
Pipe and Bolt Engine Mod-Up
dparker:
I followed this thread clear through and was/am very impressed. I voted only to register that I was interested in all the designs. My choice was hard but the rotary type of valve intrigued me enough to possibly try to incorporate it into some future model I may make. My models do not compare to most of the fine machining on this site but I enjoy reading the posts each day---Thank You for the fine site and many hours of entertainment.
vtsteam:
Polling closes in about an hour, folks, get yer choices in while ye can!
:mmr: :beer:
mattinker:
This is a spoilt ballot, I couldn't decide between the entrants! All merit worthy, interesting contributions!
Regards, Matthew.
shipto:
Congratz Russell I am not at all disapointed to lose out to such a great well made design and to be honest I am surprised to get the votes I did so thanks to all who voted.
Brass_Machine:
Ok guys!
I know I am behind on making the trophy, but I will get it made as promised. It just needs to warm up a touch before I can get out into the unheated shop!
Eric
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version