The Shop > Our Shop
Working on a new tiny shop
vtsteam:
I don't have a bending brake, so I used two pieces of angle iron clamped in the new bench's vise:
vtsteam:
Some gentle tapping with a soft hammer while applying pressure by hand folds it flat:
vtsteam:
Edges done, now folding the bottom flange:
vtsteam:
Bottom flanges done, now folding the corners. I used a piece of pine offcut from the drawer slides. Hardwood would have been preferable as a permanent addition to a new "bending tool" collection, but the pine served....
vtsteam:
Trying the cover piece in position:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version