| The Shop > Our Shop |
| Working on a new tiny shop |
| << < (24/38) > >> |
| vtsteam:
I don't have a bending brake, so I used two pieces of angle iron clamped in the new bench's vise: |
| vtsteam:
Some gentle tapping with a soft hammer while applying pressure by hand folds it flat: |
| vtsteam:
Edges done, now folding the bottom flange: |
| vtsteam:
Bottom flanges done, now folding the corners. I used a piece of pine offcut from the drawer slides. Hardwood would have been preferable as a permanent addition to a new "bending tool" collection, but the pine served.... |
| vtsteam:
Trying the cover piece in position: |
| Navigation |
| Message Index |
| Next page |
| Previous page |