| The Shop > Our Shop |
| Protecting One's Assets |
| << < (3/5) > >> |
| vtsteam:
I don't know Andrew, but sub freezing sand would be unpleasant. Warm properly tempered greensand is a pleasure to work with. For small or thin parts, chill is also a factor in filling the mold well. I'm thinking of something , low wattage, with, say, a 24 hour timer that I could turn on the night before molding. But you'd want it to be safe enough to trust unattended. I've got an old unused portable cooler/ice chest that I could store the sand in. It would only take minimal wattage to warm it up overnight. But what to use? |
| awemawson:
A zig zag of copper tube, or (to prevent corrosion) a coil of plastic heating pipe, with water from your clone Lister engine circulating through it under the sand ? |
| RussellT:
If it's one of the portable coolers based on a Peltier device I think you could just reverse the polarity to make it a heater - you might need some way to distribute the heat away from the device. Russell |
| vtsteam:
No Russell, it's just an ice chest. Maybe something like this? http://www.amazon.com/Hydor-25w-Hydrokable-Substrate-Heater/dp/B0006JLPGI |
| steampunkpete:
--- Quote ---No Russell, it's just an ice chest. Maybe something like this? http://www.amazon.com/Hydor-25w-Hydrokable-Substrate-Heater/dp/B0006JLPGI --- End quote --- That Substrate heater looks like the kit for the job; I wish I had known about these. If Russell has got a nice chest I would refrain from mentioning it - that sort of post could get you into trouble! :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |