Gallery, Projects and General > Project Logs
Tiny Vertical Based On G. Britnell's Design
<< < (6/18) > >>
Joules:
You bet, with open mouth awe  :drool:
awemawson:
Oh yes - watching avidly  :thumbup:
Manxmodder:
We're all lost for words  :jaw:  :clap: :clap:

I notice that Liz seems to be doing all the donkey work recently,has Jack been promoted to the hydraulics dept?......OZ.
vtsteam:

--- Quote from: sbwhart on December 18, 2014, 10:45:22 AM ---IS THERE ANY ONE OUT THERE  :wack:

--- End quote ---

No.  :coffee:
sbwhart:

--- Quote from: Manxmodder on December 18, 2014, 02:39:41 PM ---We're all lost for words  :jaw:  :clap: :clap:

I notice that Liz seems to be doing all the donkey work recently,has Jack been promoted to the hydraulics dept?......OZ.

--- End quote ---

--- Quote from: awemawson on December 18, 2014, 11:21:36 AM ---Oh yes - watching avidly  :thumbup:

--- End quote ---

--- Quote from: vtsteam on December 18, 2014, 05:53:42 PM ---
--- Quote from: sbwhart on December 18, 2014, 10:45:22 AM ---IS THERE ANY ONE OUT THERE  :wack:

--- End quote ---

No.  :coffee:


--- End quote ---

--- Quote from: Joules on December 18, 2014, 11:17:20 AM ---You bet, with open mouth awe  :drool:

--- End quote ---

Phew that's a relief I was beginning to think every one had been abducted by aliens from the planet lurker

  :borg: :borg: :borg: :borg:

 :D

Thanks for checking in Chaps



Got  few more bits made:- reversing arm:- first I drilled the holes in the required position then filed it roughly to shape, for the handle which is silver soldered to the arm I first cut a 1mm slot in a short piece of bar  and then roughed the handle out.



Then silver solder the arm to it, this pic doesn't look nice but it got potential.



Then back onto the lathe and finished it off.



Then the little bracket that hold the arm. Using the now well tried spin indexer method first cut a 1mm slot.



Then using the indexer to manipulate things mill is to shape and drill holes where required.



Cut it from the bar and tidy up with some needle files.

Next up the two links:- drill two 1mm holes 11mm apart then with a couple of short lengths of 1mm bar (I used the off cuts from the slotted screws) in the holes resting across the jaws of a small vice mill to width the result is a nice neat link.



Her's a group shot



I've been getting paranoid about losing one of these tiny beasts to I've started to wire them together.



Cheers

Stew



Navigation
Message Index
Next page
Previous page

Go to full version