Gallery, Projects and General > Project Logs
Transmission for table feed
<< < (5/5)
scout800:
Thanx Baron, you have a finely honed imagination. That is a nice quality to have , and fortunately that quality seems to be in abundance on this site and makes it rather interesting. Unfortunately that quality seems to be dwindling out in the world, oh well at least we have a place we can go to supplement our qualities. Thanx for sharing I appreciate it.



                                                                                                    Dave.
Mike Bondarczuk:
Hi Baron,
Just found this thread and have been looking for an x axis motor drive for my old Chester 626 mill as the new commercial units do not fit the short shaft fitted.
Would you be able to indicate where your build log is sited so that I can find it and have a look to see how I can also use a windscreen wiper motor as a drive unit.
Many thanks in advance,
Mike
BaronJ:
Hello Mike, Guys,

This is where the build log is :-
<http://www.homemodelenginemachinist.com/showthread.php?t=23130>

I think I did another one somewhere.  If I can track it down I'll post that one as well.

Navigation
Message Index
Previous page

Go to full version