Gallery, Projects and General > Project Logs
Poppin Engine build.
<< < (15/15)
Stilldrillin:

--- Quote from: awemawson on February 21, 2015, 04:20:27 PM ---Relevant graphs are on page 2
http://www.farnell.com/datasheets/22660.pdf

They quote 250 deg C as the temperature to raise it to to break the joint

--- End quote ---

You are quite correct, Andrew!  :thumbup:

But, I would be happy to use, what I have always used. In this small, lightly stressed application........

David D

Stilldrillin:

--- Quote from: ian_in_the_midlands on February 21, 2015, 05:31:07 PM ---What sort of temperatures is the cylinder likely to reach?

--- End quote ---

At the standard end. Not much, above the temp of boiling water. If at all.......

David D
fcheslop:
Will it not be possible to simply drill the holes deeper and rethread?? or drill and tap the frame for a couple of grub screws to lock the cylinder into the frame.
What size did you use 2mm
cheers
Navigation
Message Index
Previous page

Go to full version