Gallery, Projects and General > Project Logs
Poppin Engine build.
dawesy:
Myfordboy on you tube did a video on lapping a cylinder.
If this one needs it (though it sounds like you've got it spot on) it could help.
Stilldrillin:
This is my method.
Piece of dowel. Minus a thou or so, on bore size.......
Smear of fine grinding paste. Plus oil, as time goes on. Around 80rpm.......
The cylinder is oscillated backwards n forwards. Reversing occasionally on the lap. Until all feels smooth with no tight spots.
Works for me! :thumbup:
David D
ian_in_the_midlands:
I have seen the video from myforboy where he is lapping a cylinder. One of the few videoes I could find showing the lapping actually being done. I have watched and enjoyed alot of his videos. If I find I do need to lap the cylinder I will try your method David. Thanks. Before I do that though I may polish the cylinder a little using the piston. What abrasive, if any would I use for this? I do not want to risk anything that might embed itself into the cast iron. Someone recommended tooth paste but that seems a little course. I thought maybe just using oil or possibly powdered chalk?
lordedmond:
Fine grade Time Saver powder is the bees knees for laping
It breaks down during use and becomes none abrasive , it can and is used in industry to bed in gear boxes the fact that it breakes down meand that the gear box will not need dismantling for cleaning
I will get a link
Here you go
http://www.steamsupplies.co.uk/category/engineering-supplies/sub,36/30/1/0
Stuart
gmac:
And a booklet to go with it.....
http://www.newmantools.com/lapping/timesaver_booklet.pdf
You made me go looking..... :thumbup:
Cheers Garry
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version