Gallery, Projects and General > The Design Shop

Repton Ball Turner

<< < (2/2)

Will_D:
Thanks for the comments. Will save the wonga for another project. At the moment I am back to:

X^2 + Y^2 = r^2  (Eqatuon of the circle.

Now used xcel to set out a set of X,Y coordinates and then uses a small parting tool to do the roughing. Then send then misses shopping and in goes the form tool ( Have two ground up: HSS and also TC)

I do like the look of Bill Todds set up but to make a small rigid version (to cut a 8mm semi circle) would be a challenge but hey we are engineers!

Navigation

[0] Message Index

[*] Previous page