| Gallery, Projects and General > The Design Shop |
| Using digital callipers |
| (1/3) > >> |
| Will_D:
I am sure someone else has suggested this but here goes: Lathe Work 101: Turning a shaft down to size: Old Way: Measure the stock, take a cleaning cut (to round the stock) then measure again. On a piece of paper: Subtract desired from actual and divide by 2 (depends on your dials!). This is then the amount to remove. Take more cuts and repeat the above until finished! New Way: As most of us use digital callipers: Round the work as above. Manually set the callipers to finished size and then zero them. Apply callipers to work, measure, and divide the reading by 2 – no need for paper! Ok so this is for getting very close, a precision mike is still the way to go |
| Manxmodder:
Will D,I have used that method for many years. It's one of the real advantages of digital scales. Same technique applies for digital micrometers......OZ. |
| AdeV:
I still use the first method, but that's because I'm usually working in millimetres, and my lathe works in inches... |
| awemawson:
Getting a DRO on my lathe was 'The Best Thing'. I take a clean up cut to concentricity. Then I take a cut of the doc I expect to use and measure the part. Set the DRO to that value and cut until I have two or three passes left. Once more I measure the part, make any correction necessary to the DRO, and cut to finished size. This way you can take a decent cut as the final cut, which I find advantageous using indexable carbide inserts. No reason that a digital vernier cannot be used in exactly the same way as my DRO. I have to say I never look at the dials on the lathe, only the DRO ! |
| Will_D:
--- Quote from: AdeV on October 30, 2014, 06:04:47 AM ---I still use the first method, but that's because I'm usually working in millimetres, and my lathe works in inches... --- End quote --- So set to say 32 mm manually, zero it, press the ins/mm button, now when you read it the amount to remove will be in inches. |
| Navigation |
| Message Index |
| Next page |