Gallery, Projects and General > Project Logs
Scott Vacuum Engine......
fcheslop:
Nowt wrong with Geordie castings marra must be the pollution down int Derbyshire
:D
Stilldrillin:
Dunno about pollution, Frazer.
I reckon it was coffee grounds............
Finished the re sleeving. All went well........
I decided to house the bearings, inside the flywheels.
Opened out with end mills, in 2mm steps.......
Final pass, with 13mm slot drill, 5.5mm deep.........
Should be a nice shove in fit, probably..........
Sandwiched the cam, between two 5mm thick cast iron discs. Drilled & tapped m3. All held with sleevelock........
Slips in here, nicely. Plugged the grub screw hole, with it's annoying click........
A bit of clearance, here........
And there........
Screwed it all together. First flick, away it went! :bugeye:
And the video. Cos, I know someone will ask.........
It's now in lots of pieces, for final finishing and assembly.........
Thanks for looking in!
David D
fcheslop:
Nice work marra :bow:
No coffee grounds up here the quacks have banned me from drinking the filthy stuff anymore :D just have to stick with the malt.
Cheers
vtsteam:
Oh that looks really nice running David! Can't wait to see it finished....... :coffee: :thumbup:
spuddevans:
That runs really nice! :thumbup: :thumbup: :thumbup:
Tim
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version