Gallery, Projects and General > Project Logs
Scott Vacuum Engine......
<< < (20/26) > >>
fcheslop:
Nowt wrong with Geordie castings marra must be the pollution down int Derbyshire
 :D
Stilldrillin:
Dunno about pollution, Frazer.
I reckon it was coffee grounds............ 



Finished the re sleeving. All went well........





I decided to house the bearings, inside the flywheels.

Opened out with end mills, in 2mm steps.......




Final pass, with 13mm slot drill, 5.5mm deep.........




Should be a nice shove in fit, probably..........




Sandwiched the cam, between two 5mm thick cast iron discs. Drilled & tapped m3. All held with sleevelock........




Slips in here, nicely. Plugged the grub screw hole, with it's annoying click........




A bit of clearance, here........




And there........




Screwed it all together. First flick, away it went!  :bugeye:




And the video. Cos, I know someone will ask.........




It's now in lots of pieces, for final finishing and assembly.........




Thanks for looking in! 

David D



fcheslop:
Nice work marra :bow:
No coffee grounds up here the quacks have banned me from drinking the filthy stuff anymore :D just have to stick with the malt.
Cheers
vtsteam:
Oh that looks really nice running David! Can't wait to see it finished....... :coffee: :thumbup:
spuddevans:
That runs really nice!  :thumbup: :thumbup: :thumbup:


Tim
Navigation
Message Index
Next page
Previous page

Go to full version