| The Shop > Tools |
| Taking the woble out of a Grinder |
| << < (2/2) |
| Stilldrillin:
Stew, Well told & shown..... :clap: I did the same thing to my cheapo grinder, just over a year ago, as I couldn`t tighten the wobbly wheels! One unscrewed as I tightened the other! Not enough friction between washer & tiny step..... ::) My 1" dia bushes are a push fit over the .6??" dia portion, with a 1mm wide portion at .500" bore as a dead stop against the support step. I held my washers in my outside chuck jaws, & faced the boss/ bush location area only. No more built in wobbability factor! :thumbup: Good feeling innit? :ddb: :ddb: :ddb: David D |
| Navigation |
| Message Index |
| Previous page |