Home Base > Introductions
New member from Arizona
dawesy:
Hello and welcome. Look forward to seeing your madmodding :)
scout800:
Thanx again Gentlemen my floor is only clean because I haven't done any thing yet.... However I'm in the process of trying to dream up some sort of small transmission that I need to build for the table feed on my small mill. By the way it's a older Bench Master mill rowbare , I haven't really used it yet, it's trammed in and hell bent for stout , so hopefully it will be a nice machine to use. I will post a pic of the gear motor I bought for the feed and may bee I can get some input from you Gentlemen that might help me, thanx again. I wonder should I post here or elsewhere on this site ? DAVE.
Stilldrillin:
--- Quote from: scout800 on November 20, 2014, 07:26:39 PM --- I will post a pic of the gear motor I bought for the feed and may bee I can get some input from you Gentlemen that might help me, thanx again. I wonder should I post here or elsewhere on this site ? DAVE.
--- End quote ---
Hi Dave.
That sounds to be a candidate for the, Project Logs section...... :thumbup:
We'll be watching! :smart:
David D
Brass_Machine:
Hi Dave,
Welcome to the collective :borg:
Eric
Navigation
[0] Message Index
[*] Previous page
Go to full version