The Shop > Software Tools
Just bought Cambam.. very delighted.
awemawson:
Doesn't look too expensive if it's as good as people say.
It's not obvious on first reading of Stuart's link whether the G code generator is tweakable to the vagaries of different machines. Does it use a configurable post processor of some form?
Joules:
Andrew,
have a visit to the CamBam forum. It is active and with a knowlegable user base.
http://www.cambam.co.uk/forum/
As far as I know you can pretty much develop your own post processor if you are so inclined.
awemawson:
Quite a few names we know over on that forum !
Swarfing:
Another user here and always been pleased with it, run mine on linux.
Dawai:
YEAH, I have been trying to figure out how to "trick" cambam into doing knitting. in a gcode cycle-repeat.. (really).. from 3d clothing. I bought two needlebeds, 200 more machine knitting needles from Jolly ole ENGLAND..
(Honey-doo) My wife wants this first simple one to knit afghans, (seven feet wide).. and then I can copy this full cnc one she says.. http://hackaday.com/2014/02/20/openknit-the-open-source-knitting-machine/ Gerard is the guy who did this.. over Thar.. some-whar.. Sharp as a tack he is...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version