| The Shop > Software Tools |
| Just bought Cambam.. very delighted. |
| << < (2/4) > >> |
| awemawson:
Doesn't look too expensive if it's as good as people say. It's not obvious on first reading of Stuart's link whether the G code generator is tweakable to the vagaries of different machines. Does it use a configurable post processor of some form? |
| Joules:
Andrew, have a visit to the CamBam forum. It is active and with a knowlegable user base. http://www.cambam.co.uk/forum/ As far as I know you can pretty much develop your own post processor if you are so inclined. |
| awemawson:
Quite a few names we know over on that forum ! |
| Swarfing:
Another user here and always been pleased with it, run mine on linux. |
| Dawai:
YEAH, I have been trying to figure out how to "trick" cambam into doing knitting. in a gcode cycle-repeat.. (really).. from 3d clothing. I bought two needlebeds, 200 more machine knitting needles from Jolly ole ENGLAND.. (Honey-doo) My wife wants this first simple one to knit afghans, (seven feet wide).. and then I can copy this full cnc one she says.. http://hackaday.com/2014/02/20/openknit-the-open-source-knitting-machine/ Gerard is the guy who did this.. over Thar.. some-whar.. Sharp as a tack he is... |
| Navigation |
| Message Index |
| Next page |
| Previous page |