| Gallery, Projects and General > How do I?? |
| Rotary-Table convertion |
| (1/1) |
| HS93:
I have just bought one of these Rotary-Tables I was after one that had the stepper on but they are still out of stock and I need it now for a job, I saw an artical some time ago about converting this one to cnc but cannot rember where can anybody Help, Thanks Peter :dremel: http://www.arceurotrade.co.uk/Catalogue/Workholding/Rotary-Tables |
| bogstandard:
Peter, John Stevenson is your man. You should have spoken to me first, John gave me some very good info about those a few days back. John |
| John Stevenson:
Peter, As far as I know there has been no conversions for this table on line. There are many for the Vertex type. Just removing the handle and fitting a stepper isn't too difficult but the full conversion carried out by ARC consists of changing the plain worm to one running in needle roller bearings and double thrusts fitted. JS. |
| HS93:
Ok thanks for that , I thought I had seen one some time ago but I am getting old and do forget things and think I have done things so this must be one of them , I have prob seen the vertex one as I was going to get one of them first but decided I had always liked the look of this one so I would go for it.I have been hopping for some time that the cnc vertion would be back in stock but I was in need for one to start a job so I just got it without . anyway great service 24 hours from ordering it was hear today and I need to get the rest of the gunk off, it is a lot lot heavey'r than I thought it would be. but the only ones I have ever handels are the cheep ones at the shows and the look of them has put me off. Peter |
| Navigation |
| Message Index |