Gallery, Projects and General > Project Logs
Twin Cylinder Steam Engine
Darren:
I thought I'd have a go at starting the cylinder block tonight from a sash weight.
I picked on the square one of my 3 that I have
Scored all four sides with the disk cutter, inc the end as suggested by Bogs :thumbup:
Took it outside and threw it against the concrete floor, nothing happened, tried again, and again, and again. By now I was really belting it.
I resorted to finding a granite rock in the garden and whacking it against a sharp edge along the score marks. It took several goes but finally it gave in.
I then tried to knock the end off with a sharp cold chisel and a lump hammer. I gave up in the end, I just couldn't hit it hard enough.
I was suprised just how tough this cast iron is, didn't seem very brittle to me :lol:
I then decided that to remove the hard abrasive crust I would lathe it off with a half beaten carbide tip. After all I have enough of them and better that than ruin a milling cutter I thought. Managed it too with just the one tip.... :thumbup:
It was very uneaven and the surface slightly porus so took a bit of doing.
Off to the miller for a tidy up
Alas, it looks as if it's going to be a tad too small in height, ended up at 29mm and the plans call for 32mm, not much in it but 3mm is 3mm.
Not sure what to do now, I don't currently have any other suitable material....... :bang:
Divided he ad:
Personally I'd get another one made similar to that one and make 2 single cylinders out of 'em.... Round off the outsides etc, make a feature out of 'em
Then use the head etc to tie them together.
Well that's what I'd do anyway :borg:
Waiting to see this run still...... Do I have to do the rain dance some more to keep you inside and working? :ddb:
Ralph. :)
Darren:
You know I was thinking exactly the same thing, just not shure if I'd be making life a bit too hard for myself...dunno why, fear of the unknown I suppose... :scratch:
You can do a rain dance and spoil my garage build if you like, but only if you video it and stick it on Utube :lol: :lol: :lol:
Garage is coming along....I'll have to do an update.... :)
Darren:
Slight problem with the two cylinder idea,
Top and bottom plate are drilled for one block....I'd have to make some new ones.... :bang:
How about a slightly shorter piston and/or a thicker head with the 3mm built in?
Tired now, will look at the plans tomorrow...
kvom:
Bottom plate wouldn't change. Top plate would need different holes for mounting the block parts.
Leaving it 3mm short would be bad as the inlet holes spacing would be off.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version