Gallery, Projects and General > Project Logs

Twin Cylinder Steam Engine

<< < (30/38) > >>

sbwhart:
Well done that man.

 :clap: :clap: :clap: :clap: :clap:


Hope you remembered to mark them up so you don't get them mixed up  :doh:

Cheers

Stew

NickG:
Darren, they are looking good, great idea using the hex bar and like the ultra think parallels!  :thumbup:

Well, I probably won't be back on here until the weekend, at which point I may have met some of you at Harrogate hopefully.  :D

Nick

Darren:

--- Quote from: bogstandard on May 04, 2009, 03:11:13 PM ---

Now you have drilled your new ones quite successfully, you must be feeling a lot happier.


--- End quote ---

Never a truer word spoken, I was starting to worry about my machinery being a bit naff, thankfully this normal brass drilled very smoothly.

I did swipe the tips of the drill bit to take the edge off, though I don't know how much this helped cos I wasn't taking any chances with a sharp one.
You could say I'd had enough of frustration by then  :lol:

Thanks for this little tip John, all added to the database for future ref  :thumbup:

Darren:

--- Quote from: kvom on May 04, 2009, 03:13:53 PM ---I love the idea of shaping the straps with the hex stock.   :headbang:



--- End quote ---

Thanks but the idea really came about due to what I had to hand that was big enough. Should look nice though  :thumbup:

Darren:

--- Quote from: NickG on May 04, 2009, 05:58:28 PM ---Darren, they are looking good, great idea using the hex bar and like the ultra think parallels!  :thumbup:

Well, I probably won't be back on here until the weekend, at which point I may have met some of you at Harrogate hopefully.  :D

Nick

--- End quote ---

Nice description, the blades where just sitting there staring at me saying, "me, me, me"  :lol:

Worked really well too  :nrocks:

Navigation

[0] Message Index

[#] Next page

[*] Previous page