| Gallery, Projects and General > Gallery |
| Press brake for a 20 ton hydraulic press |
| << < (3/5) > >> |
| DaveH:
Welded the top die to the guides, also notice a removable bottom die - just a piece of angle iron. The welds have all been cleaned up to make them look respectable :) :beer: DaveH |
| DaveH:
Time for a quick paint job Whot!!! ....................... I like yellow and it goes very nicely with the blue press :lol: A couple of things to notice I had to clean all the paint off the guide shafts - it didn't slide up and down very well with the paint. The extra supports under the base of the press brake. :beer: DaveH |
| DaveH:
I made a couple of locating 'lugs' helps to keep the brake press in the same place. A 'cup' was made and fixed to the top die again to keep everything inline. That's about it - finished. With removable bottom dies :beer: DaveH |
| shipto:
very nice I might make a smaller version for my fly press :thumbup: |
| philf:
--- Quote from: DaveH on August 21, 2014, 02:08:11 PM ---That's about it - finished. With removable bottom dies DaveH --- End quote --- Dave, Most importantly - does it work? I know little about press brakes but the fillets in the removable dies look rather too generous to me. Phil. |
| Navigation |
| Message Index |
| Next page |
| Previous page |