| Gallery, Projects and General > How do I?? |
| Off-set centers |
| (1/1) |
| Darren:
Can someone please explain what a pair of off-set centers are on a lathe, I know what centers are, but how do you off-set them :scratch: I would assume centers where centered and the work was off-set on the centers being driven by a dog? |
| Stilldrillin:
Dunno! :scratch: Crankshaft throws are turned between a pair of offset centre holes....... ::) David D |
| Darren:
Thanks David, I thought as much. Was thrown by some text I was reading earlier. Ta... :thumbup: |
| Stilldrillin:
Yer welkum! :wave: JUST read your Twin Cyl engine post. ::) Good luck! :thumbup: David. |
| Navigation |
| Message Index |